H13 Bi-Xenon Resistor Capacitor Error Free Anti-Flicker Module
SKU:
H13_cap_res_canbus_module
$14.99
$14.99
Description
The low and high beam have resistors and the high beam has a capacitor to balance out the power fluctuation of the high beam that is very common on the Dodge vehicles.
Each module has a male and female H13 connector to make this a full plug and play setup. Only thing needed is to mount the resistors to a metal non-plastic surface. The resistors get very very hot so they must be mounted using a metal screw to a metal surface. Never use double sided adhesive.
These can be used with standard bixenon relay harnesses. You will still need two - one for each lamp to prevent dash error. If your existing harness only has one input - just plug in the other side and not connect to anything - the resistors will trick the computer into thinking that it has a bulb installed.
Price is for EACH module - just like the pictures.
If you need these for both lamps - get two.
Note: This is the only one that has a built-in capacitor to prevent flickering or buzzing on the high beam circuit.
Each module has a male and female H13 connector to make this a full plug and play setup. Only thing needed is to mount the resistors to a metal non-plastic surface. The resistors get very very hot so they must be mounted using a metal screw to a metal surface. Never use double sided adhesive.
These can be used with standard bixenon relay harnesses. You will still need two - one for each lamp to prevent dash error. If your existing harness only has one input - just plug in the other side and not connect to anything - the resistors will trick the computer into thinking that it has a bulb installed.
Price is for EACH module - just like the pictures.
If you need these for both lamps - get two.
Note: This is the only one that has a built-in capacitor to prevent flickering or buzzing on the high beam circuit.
