Morimoto Capacitor Link
Morimoto Capacitor Link HD harness accessory
WHAT'S INCLUDED
Harness Accessory: One Anti-Flicker Capacitor Link
Warranty: Two Years
TECH SPECS
Fits Harnesses: All w/ 9006 inputs
Capacitor: 10,000uF
Harness Accessory: One Anti-Flicker Capacitor Link
Warranty: Two Years
TECH SPECS
Fits Harnesses: All w/ 9006 inputs
Capacitor: 10,000uF
Pair Capacitor Modules
Load 55w Resistors with 14 inch wire
Pair of 55w 6ohm Resistors with 14in wirePair of 55w 6ohm Resistors enclosed in finned aluminum sheathing for heat dispersion.
Includes: 2 x 55w 6ohm Resistors 4 x Wire Tap Connectors 2 x Metal Screws |
|
Load 3R Resistors with Adhesive backing
3R Load Resistors with Adhesive and tap connectors2 x 3R Load Resistors on PCB Board with Adhesive
4 x tap connectors Each resistor module has a PCB board with 3 resistors on it with an adhesive backing. The only resistor that has an adhesive backing built to withstand the heat of the PCB board. Made for signal or blinker lights to prevent rapid flash. Wires are made with copper, not aluminum like most of the cheaper resistors. High quality at low price. |
|
Load Resistors with Bracket
Load Resistor with Metal Bracket Pair2 x Load resistor with Metal Bracket
4 x tap connectors Used to fix rapid flash of many signal lights that have been converted to LED. May or may not solve dash error messages on certain vehicles. |
|
9003/H4 Highbeam Error Free Fix
9003/H4 Error Fix for High Beam IndicatorOne 9003/H4 waterproof error free unit
This little device connects to the other side of the vehicle connector that is connected to a bixenon HID harness with one input. Sometimes people experience problems with their dash indicator not working on high beam. This is designed to resolve it. |
|
H13 Bi-Xenon Error Free Canbus Module
H13 Bi-Xenon Resistor Capacitor Error Free Anti-Flicker ModuleThe low and high beam have resistors and the high beam has a capacitor to balance out the power fluctuation of the high beam that is very common on the Dodge vehicles.
Each module has a male and female H13 connector to make this a full plug and play setup. Only thing needed is to mount the resistors to a metal non-plastic surface. The resistors get very very hot so they must be mounted using a metal screw to a metal surface. Never use double sided adhesive. These can be used with standard bixenon relay harnesses. You will still need two - one for each lamp to prevent dash error. If your existing harness only has one input - just plug in the other side and not connect to anything - the resistors will trick the computer into thinking that it has a bulb installed. Price is for EACH module - just like the pictures. If you need these for both lamps - get two. Note: This is the only one that has a built-in capacitor to prevent flickering or buzzing on the high beam circuit. |
|