relay harness |
Universal Triple Capacitor HID Relay HarnessThis harness is a multi-function relay harness.
Has a high amperage relay enough power to power both ballasts. It can do so due to the triple capacitors on this harness. Let me explain why it has 3 capacitors and what they do. 1. Input to the relay is your switch from your vehicle, this has a capacitor to even out a dirty signal or flickering caused by DRL and will power the relay on and the extra power stored up in the capacitor will even out all that flickering to one steady signal. This makes the relay operate normally even if your vehicle has DRL. (Ground switch DRL will need to ground out the input) 2. There is one capacitor for each of the two outputs going into the ballast. These capacitors store up the power from the battery and will make the ballast operate more smoothly without going into fault mode. This will fix those pesky ballasts that you have to constantly turn on and of and on and off just to get then to turn on. (note: sometime poor quality bulbs or ballasts will fail and if you experience this with the harness you need to replace your bulb or ballast). Easy installation with a positive wire to the positive terminal on the battery and a negative wire to the negative terminal on the battery. Other harnesses you have to find two grounds near your ballast, with this easy installation triple capacitor harness you do not have to. Just attach it to the battery terminals, connect it up and your done! This is universal for any HID system that has power wires. Since this harnesses uses the common input connector for ballasts, just disconnect your wire going into your ballast and plug it into the input of the harness and plug the output of this harness in to your ballasts. Done! |